Hitachi RAK-18NH6AS - Air Cleansing Filter Installation; Attaching the Air Filters

– 17 –
AUTOMATIC OPERATION
The device will automatically determine the mode of operation, HEAT, COOLor DEHUMIDIFY depending on the current room
temperature. The selected mode of operation will change when the room temperature varies. However the mode of operation
will not change when indoor unit connected to multi type outdoor unit.
VARIOUS FUNCTIONS
n Auto Restart Control
l If there is a power failure, operation will be automatically restarted when the power is resumed with previous operation mode
and airow direction.
 (As the operation is not stopped by remote controller.)
l If you intend not to continue the operation when the power is resumed, switch off the power supply.
 Whenyouswitchonthecircuitbreaker,theoperationwillbeautomaticallyrestartedwithpreviousoperationmodeandairow
direction.
 Note: 1. If you do not requireAuto Restart Control, please consult your sales agent or OFF by remote control.
  2. Auto Restart Control is not available whenTimeror Sleep Timermode isset.
n As the settings are stored in memory in the remote controller, you only
have to press the    (START/STOP) button next time.
PresstheFUNCTIONselectorsothatthedisplayindicatesthe(AUTO)
mode of operation.
l WhenAUTOhasbeenselected,thedevicewillautomaticallydetermine
themodeofoperation,HEAT,COOLorDEHUMIDIFYdependingon
the current room temperature. However the mode of operation will
not change when indoor unit connected to multi type outdoor unit.
l If the mode automatically selected by the unit is not satisfactory,
manually change the mode setting (heat, dehumidify, cool or fan).
Press the     (START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
You can raise or lower the temperature setting as necessary by maximum
of 3°C.
Press the temperature button and the temperature
setting will change by 1°C each time.
l The preset temperature and the actual room temperature may vary
somewhat depending on conditions.
l ThedisplaydoesnotindicatethepresettemperatureintheAUTOmode.
If you change the setting, the indoor unit will produce a beep.
1
START
STOP
°C
Press the     (FAN SPEED) button,AUTO,LOW and SILENT is available.