MODEL
Fig. 13
Fig. 12
Fig. 14
Fig. 15
(5) Remove the electrical box fixing screws and
Remove P lock which binds lead wires.
et the electrical box upside down.
( Remove P.W.B. fixing screws (2 locations) and
1. Electr
cal Part
1
Remove the upper cover fixing screws and lift the
(2) Remove the service valve cover
(3) Remove the terminal plate cover
(4) Remove the right side cover
<OUTDOOR UNIT>
Radiation fin fixing screw
P.W.B. fixing screw
6
7)
8)
right side cover.
terminal cover.
valve cover.
RAC-18/25/35WED
OUTDOOR UNIT
1. Electrical parts
(1)Remove the service value cover lock screws
and lower the cover to remove it.
(2)Remove the top cover lock screw and raise the
cover to remove it.
Fig. 16
(3)Remove the front cover lock screw.
(4)Lower the right side of the front cover and pull
it forward. Then, remove the cover from the
hook.
(5)Pull the right side of the front cover a little and
pull up the left side to remove it from the hook.
Fig. 17
(6)Remove each connector and earth cable from
the lead wire. Then,remove the electrical box
MODEL RAC-50WED
cover to remove it.
GND wire fixing screw.
radiation fin fixing screws (7 locations), and
remove the P.W.B. from the support.
.
To Next Page
Loading...
