Ð 0224. Ð
Ð8Ð
Set the desired FAN SPEED with the (FAN SPEED) button (the
display indicates the setting).
(AUTO) : The fan speed changes automatically according
to the temperature of the air which blows out.
(HI) : E c o n o m i c a l a s t h e r o o m w i l l b e c o m e wa rm
quickly.
But you may feel a chill at the beginning.
(MED) : Quiet.
(LOW) : More quiet.
¥ Use the device for heating when the outdoor temperature is under 21¡C.
When it is too warm (over 21¡C), the heating function may not work in order to protect the device.
¥Inorder to keep reliability of the device, please use this device above -15¡C of the outdoor temperature.
Press the FUNCTION selector so that the display indicates
(HEAT).
As the settings are stored in memory in the remote controller, you only have
to press the
(START/STOP) button next time.
Set the desired room temperature with the TEMPERATURE buttons
(the display indicates the setting).
The temperature setting and the actual room temperature may vary
somewhat depending on conditions.
Press the (START/STOP) button.Heating operation starts with a
beep. Press the button again to stop operation.
Defrosting will be performed about once an hour when frost forms on the heat exchange of the outdoor unit,
for 5~10 minutes each time.
During defrosting operation, the operation lamp blinks in cycle of 3 seconds on and 0.5 second off.
The maximum time for defrosting is 20 minutes.
However, if it is connected to multi type outdoor unit, the maximum time for defrosting is 15 minutes.
(If the piping length used is longer than usual, frost will likely to form.)
Ð9Ð
!
"#$%
&'!
!
()*
+,
Use the device for dehumidifying when the room temperature is over 16¡C.
When it is under 15¡C, the dehumidifying function will not work.
When you want to change the operation mode, please use the FUNCTION
selector.
Set the desired temperature is available.
You also can use the FUNCTION selector to select this operation.
Press the FUNCTION selector so that the display indicates
(DEHUMIDIFY).
The FAN SPEED is set at LOW automatically.
The FAN SPEED button does not work.
Press the (START/STOP) button.
¥ Dehumidifying takes place with a target temperature which is slightly lower than the room temperature
setting. (However, target temperature is 16¡C for a temperature setting of 16¡C.)
If the room temperature becomes lower than the target value, operation stops. If the room temperature
becomes higher than the target value, operation restarts.
¥ The preset room temperature may not be reached depending on the number of people present in the room
or other room conditions.
-./01 .2
- 41 -
To Next Page
Loading...
