Press the (ON-TIMER)
button. The
(ON) mark blinks on
the display .
The device will turn on at the
designated times.
Press the
(ON-OFF) button
so that the
(OFF)
mark blinks.
Set the turn-off time
with the TIMER control
button.
Press the
(RESERVE)
button.
Press the (ON-
TIMER) button so that the
(OFF) mark lights and
the
(ON) mark blinks.
¥ The device will turn on (off) and
off (on) at the designated times.
¥ The switching occurs first at the
preset time that comes earlier.
¥ The arrow mark appearing on the
display indicates the sequence of
switching operations.
Point the signal window of the remote controller toward the indoor unit, and press the (CANCEL)
button.
The
(RESERVED) sign goes out with a beep and the (TIMER) lamp turns off on the indoor
unit.
You can set only one of the OFF-timer,
ON-timer and ON/OFF-timer.
StopStart
Start
Stop
%
&'&&$&(&(%#%)*++,
-./0
12,
,
345
Point the signal window of the remote controller toward the indoor unit, and
press the
(RESERVE) button.
The
(ON) mark starts lighting instead of flashing and the (RESERVED)
sign lights. A beep occurs and the
(TIMER) lamp lights on the indoor unit.
AM
AM
AM
PM
AM
PM
Set the turn-on time with the
TIMER control button.
Example:
The device will turn on at 7:00 a.m.
The setting of the turn-on time is now complete.
6
Set the turn-on time with the
TIMER control button.
Example:
The device will turn off at 10:30p.m. and it will be
turned on at 7:00 a.m.
The settings of the tur n-on/off time are now
complete.
7
Point the signal window of the remote controller toward the indoor unit, and
press the
(RESERVE) button.
The
(ON) mark starts lighting instead of flashing and the (RESERVED) sign
lights. A beep occurs and the
(TIMER) lamp lights on the indoor unit.
¥ The timer may be used in three ways: off-timer, on-timer and ON/OFF (OFF/ON)-timer.Set the current time
at first because it serves as a reference.
¥Asthe time settings are stored in memory in the remote controller, you only have to press the
(RESERVE)
button is order to use the same settings next time.
Set the
(TIME) button.
Example: The current time is 1:30p.m.
¥ The time indication will
disappear automatically in 10
seconds.
¥Tocheck the current time
setting, press the
(TIME)
button twice.
The setting of the current time
is now complete.
Set the current time with
the TIMER control button.
6
Press the (TIME) button
again.The time indication starts
lighting instead of flashing.
Set the turn-off time with the
TIMER control button.
Point the signal window of the remote controller toward the indoor unit, and
press the
(RESERVE) button.
The
(OFF) mark starts lighting instead of flashing and the (RESERVED)
sign lights. A beep occurs and the
(TIMER) lamp lights on the indoor unit.
Example: The device will turn off at 11:00p.m.
The setting of turn-off time is now complete.
PM
PM
AM
PM
PM
PM
- 43 -
To Next Page
Loading...
