Ð 0227 Ð
Ð11Ð
RESET
.....
When the AUTO fan speed mode is set in the cooling/heating operation:
For the heating operation
●
The fan speed will automatically change according to the temperature
of discharged air.
●
When the difference of room temperature and setting temperature is
large, fan starts to run at HI speed.
●
When the room temperature reaches setting temperature, fan speed
changes to LOW automatically.
●
When the difference of room temperature and setting temperature is
large, fan starts to run at HI speed.
●
After room temperature reaches the preset temperature, the cooling
operation, which changes the fan speed and room temperature to obtain
optimum conditions for natural healthful cooling will be performed.
For the cooling operation
You can use the device simply as an air circulator. Use this function to dry the interior of the indoor
unit at the end of summer.
Press the FUNCTION selector so that the display indicates
(FAN).
Press the (FAN SPEED) button.
Press the (START/STOP) button. Fan operation starts with
a beep. Press the button again to stop operation.
Ð10Ð
û
C
RESET
û
C
Press the FUNCTION selector so that the display indicates
(COOL).
Set the desired FAN SPEED with the
(FAN SPEED) button
(the display indicates the setting).
(AUTO): The FAN SPEED is HI at first and varies to
MED or LOW automatically when the preset
temperature has been reached.
(HI) : Economical as the room will become cool
quickly.
(MED) : Fan speed slow.
(LOW) : Fan speed slower.
Set the desired room temperature with the TEMPERATURE
button (the display indicates the setting).
The temperature setting and the actual room temperature may
vary some how depending on conditions.
Press the
(START/STOP) button. Cooling operation starts
with a beep. Press the button again to stop operation. The
cooling function does not start if the temperature setting is
higher than the current room temperature (even though the
(OPERATION) lamp lights). The cooling function will start as
soon as you set the temperature below the current room
temperature.
■
As the settings are stored in memory in the remote controller, you
only have to press the
(START/STOP) button next time.
Use the device for cooling when the outdoor temperature is Ð10~42¡C. (Only RAM-80QH5: 10~42¡C)
If humidity is very high (over 80%) indoors, some dew may form on the air outlet grille of the indoor unit.
- 84 -
To Next Page
Loading...
