– 34 –
ATTACHING THE AIR PURIFYING FILTERS
1
Open the front panel
● Pull up the front panel by holding it at both sides with
both hands.
2
Remove the Pre-fi lter
● Push upward to release the claws and pull out the
Pre-fi lter.
3
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into Pre-fi lter frame.
4
Attach the Pre-fi lters
● Attach the Pre-fi lters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the Pre-fi lters, push the front panel at
three arrow portions as shown in fi gure and close it.
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop operation
and switch off the power supply.
CAUTION
!
!
CAUTION
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
NOTE
● In case of removing the air purifying fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use for 1
year time. Type number for this air purifying fi lter is <SPX-CFH22>. Please use this number for ordering
when you want to renew it.
● Do not operate the air conditioner without Pre-fi lter. Dust may enter the air conditioner and fault may
occur.
RAK-50PPA(T)-3 34RAK-50PPA(T)-3 34 3/14/14 12:38 PM3/14/14 12:38 PM
To Next Page
Loading...
Need help?
General
