Operation instructions
7
LOCK function
Press TIME ON and TIME OFF to start .buttons together LOCK functionfor 3 seconds
The appears on the icon will the LCD
LOCK function
Press TIME ON and TIME OFF buttons together again to stop LOCK function.for 3 seconds
The disappeared from icon will the the LCD
Press together
for 3 seconds
1
CLEAN
2
MUTE mode
IFEEL function
IFEEL function
ECO mode
ECO mode
In this mode, the air conditioner will work with low noise performance.
In this mode, you can start the SLEEP mode at the same time.
Note:
* Press MODE, FAN SPEED, SMART or SUPER button to cancel MUTE mode.
* MUTE button is only available in COOLING, HEATING and FAN ONLY mode.
MUTE mode
In this mode, the air conditioner will bring you energy saving performance by lower running currency.
* ECONOMY button is ineffective in SMART and SUPER mode.
* SMART and SUPER ECONOMY
* Press ON/OFF, MODE, TEMP ±, FAN SPEED, SLEEP, QUIET or ECONOMY
button to cancel ECONOMY mode.
buttons are not available in mode.
Note:
PRESS
PRESS
The temperature sensor built in remote controller is activated.It can sense its surrounding temperature,
and transmit the signal back the unit,the unit can adjust the temperature so as to provide maximum
comfort.
Note:
Advice to put the remote controller in the place where the indoor unit receive signal easily.
Advice to cancel the IFEEL mode so as to save energy when stopping the air conditioner.
CLEAN
CLEAN
PRESS
LOCK function
Press
CLEAN to start .
When the air conditioner is in standby, and the mode of remote controller is in Cooling or Dry,
button Clean mode,then the indicator “ ” will display on LCD.
CLEAN function
Press ON/OFF or MODE button can exit the Clean mode, then the
indicator “ ” will disappear.
After the clean process finish, the air conditioner will return to Cooling or Dry as preset,
while the indicator“ ” on remote controller will display for about 10 mins.
PRESS
. Clean mode is ineffective in TURBO mode
ECO IFEEL CLEAN
To Next Page
Loading...
Need help?
General
