1. Front Panel
(1)Pull up the washable panel by holding it at both
lower sides with both hands.
Fig. 1
(2)When the panel opens full, push the inner part
of the right arm into the inside and pull the panel
forward while closing it gradually.
Fig. 2
2. Front cover
Fig. 3
Indicating P.W.B.
Control P.W.B.
Support hook
3. Control P.W.B. and Indicating
P.W.B.
(1)Remove each connector from the lead wire.
(2) Remove the four P. W. B . suppor ts from the
control P. W. B .
(3)Pull the support hook at the upper side of the
indication lamp of the indicating P. W. B . and pull
out the P. W. B . forward.
Fig. 4
Procedure for Disassembly and Reassembly
INDOOR UNIT
RAS-08PH1,RAS-10PH1, RAS-14PH1
7(0325$5<
6:,7&+
105
securely. Then, push the center of the front
cover to lock the claws.
(1)Check that the drain pan is securely attached.
(2)After installing the front cover onto the unit,
(3)Tighten the two screws.
hook three claws
at upper side of the cover
To Next Page
Loading...
