1. OPTION LIST
:
AUTO fan speed is invalid for “FAN” mode.
AUTO fan speed is the default setting under DRY mode, and it can’t be adjusted.
MEDIUM
HIGH
LOW
AUTO
AUTO
6.. Group control
This wired controller can control air conditioners sharing a common system in groups via a adaptor, with one primary unit and seven
secondary units at most. The status of the secondary unit keeps the same with that of the primary one and the latter command latter
command from the primary controller or secondary controller has the prior operation order.
” and the quantity of secondary units that connected with units that
:
The address of secondary controller is set by the adaptor.
After press down “ ” button for 3s to turn the primary controller off completely, icon “
connected with will be displayed on the screen.
:
This function is only applicable to the air conditioning units with the swing function.
None
No display
UP-DOWN AND LEFT-RIGHT
Airflow Swing
Up/Down Airflow Swing
Left/Right Airflow Swing
5. Airflow swing setting
” button to adjust the Under the ON conditions or under the OFF conditions when TIMER ON function is enabled, press the “
airflow direction.The airflow direction setting will change in the following sequence by default:
Function setting
How to active:
Press and hold " " button for 3s with the working unit to activate the super mode, and the
” icon.
AUTO
If you operate the Super mode under COOLING, DRY and FAN ONLY modes, the unit will
automatically go into forced cooling mode with lowest set temperature, or go into forced
heating mode with highest set temperature under the heating mode.
The maximum cooling/heating capacity can be activated at the super mode.
How to cancel:
Super mode will be cancelled if change mode or power off.
:
For the indoor units without ultrahigh fan speed function, it will be adjusted to run at high fan speed under the super mode, with high fan speed
mode icon “ ” displayed.
Super mode
:
For the indoor units without ultralow fan speed function, it will be adjusted to run at low fan speed under the mute mode,
with low fan speed mode icon “ ” displayed.
How to cancel:
Mute mode will be cancelled if change mode or power off.
Mute mode
The mute mode reduces the noise by changing the fan speed of indoor unit so as to keep
quiet during operation at night.
How to activate:
In the COOLING/HEATING mode during appliance operation, press and hold " " button for 3s to activate silent
mode, the indoor unit will run at the ultralow fan speed, and displays
O
“ Mute ” , “ ” , “ ”, “
AUTO
indoor unit will run at the ultrahigh fan speed, and displays “ ”, “ ”, “
AUTO
To Next Page
Loading...
