1. Air outlet grille.
2. Rear cover.
3. Lower part of service cover.
4. Fixing portion for outdoor temperature thermistor.
5. Air inlet grille (rear side).
6. Pull
N O T E
• DO NOT touch electrical components while the LED1 (Red) is ON to avoid electrical shock. Wait until the LED
turns off.
¿ Removing outdoor fan motor
1 Remove the service cover following Removing service cover, see on page 414.
2 Remove the outlet grille following Removing air outlet grille, see on page 415.
3 Remove the upper cover following Removing upper cover, see on page 415.
4 To remove the propeller fan, remove the cap nut and washer which fix the propeller fan onto the motor shaft. (Use a
puller when the propeller fan and motor shaft are fixed too tightly).
1. Upper cover.
1. Fan motor lead wire.
2. Motor clamp.
3. Fan motor.
4. Screw with spacer.
5 Remove the fan motor connector from the PCB3 and PCB5 at the electrical box.
Cut the plastic tie with nippers, which fixes the fan motor lead wire onto the motor clamp.
To Next Page
Loading...
