Hitachi RAS-E10CZ - Air Flow Louver Adjustments; Left and Right Airflow Direction; Upward and Downward Airflow Control

– 12 –
AIR FLOW LOUVERS ADJUSTMENTS
1. Adjusting the left and right air fl ow directions
Move the vertical air fl ow louvers as illustrated,
to adjust the air fl ow to fl ow towards the left or
right directions.
2. Adjusting the downward air fl ow direction.
During the “Dehumidifying” or “Cooling” operating
modes, the horizontal air flow louvers are
automatically adjusted to suit the air fl ow angles
of each operating mode. The air fl ow louvers
are designed to direct air fl ow in upward and
downward directions. Pressing the automatic air
fl ow control button, these air fl ow louvers can also
be adjusted to any air fl ow angle of one’s choice.
Press the AUTOMATIC AIR FLOW DIRECTION
once will activate the horizontal air fl ow louvers
to direct the air fl ows upwards and downwards.
Press the control button again, the horizontal air
fl ow louvers will stop moving and remain fi xed at
the position at the point when the control button
was pressed
During the “Dehumidifying” or “Cooling” operating
modes, set the horizontal air fl ow louvers to move
within the range as recommended in the illustration
Adjusting the air fl ow louvers will direct air fl ows
to assist in reducing the room temperature and
to correct any temperature imbalance
During the “Cooling” operating mode, do not adjust
the horizontal air fl ow louvers to swing outside the
range as indicated by arrows in the illustration.
Do not operate the horizontal air fl ow louvers in
durations longer than it is necessary. Condensate
may form and drip along the horizontal air fl ow
louvers.
After stopping the operations of the unit by
pressing control button, the horizontal air
fl ow louvers will move to park at a position that
covers up the air outlet vent.
While the automatic air fl ow direction mode is
in operation, any physical adjustment to the
horizontal air fl ow louvers will shift the swing range.
However, with no further physical adjustments,
the air fl ow louvers will readjust automatically
to the original swing range setting. (Should the
louvers could not return to the original swing range
setting, stop the operation of the air conditioner
unit, remove the power supply plug and re-plug
it into the power mains socket and restart the air
conditioner unit. This will return the swing range
to its original setting)
(EN1) RAS-E10CZ.indd 12(EN1) RAS-E10CZ.indd 12 5/7/10 10:54 AM5/7/10 10:54 AM