– 16 –
ATTACHING THE AIR PURIFYING AND DEODORIZING FILTERS
1
Open the front panel.
● Pull up the front panel by holding it at both sides
with both hands.
2
Remove the pre- lter.
● Push upward to release the claws and pull out the
lter.
3
4
Attach pre- lters.
● Attach the pre- lters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the pre- lters, push the front panel at
three arrow portion as shown in gure and close it.
Cleaning and maintenance must be carried out only by quali ed service personal. Before cleaning,
stop operation and switch off the power supply.
CAUTION
!
!
CAUTION
NOTE
Claws
(4 places)
Attaching the air purifying and deodorizing lters
to the lter.
● Attach the air purifying and deodorizing lters to
the frame by gently compress its both sides and
release after insertion into lter frame.
Do not bend the air purifying
and deodorizing lter as it may
cause damage to the structure.
● In case of removing the air purifying and deodorizing lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
purifying and deodorizing lters are used. So, set the fan speed to "HIGH" when using it in this
condition.
● Air purifying and deodorizing lters are washable and reusable up to 20 times by using vacuum
cleaner or water rinse under running tap water. Type number for this air purifying filter is
<SPX-CFH5>. Please use this number for ordering when you want to renew it.
● Do not operate the air conditioner without lter. Dust may enter the air conditioner and fault may
occur.
(EN3) RAS-E18CY (J)-DD 0000167C.indd 16 6/30/10 9:22 AM
To Next Page
Loading...
