– 17 –
ATTACHING THE AIR PURIFYING FILTERS
1
Open the front panel
● Pull up the front panel by holding it at both sides
with both hands.
2
Remove the pre-fi lter
● Push upward to release the claws and pull out the
fi lter.
3
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into fi lter frame.
4
Attach the pre-fi lter
● Attach the pre-fi lter by ensuring that the surface
written “FRONT” is facing front.
● After attaching the pre-fi lter, push the front panel at
three arrow portion as shown in fi gure and close it.
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
CAUTION
CAUTION
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
NOTE
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying fi lters are not washable and can be use in 1 year time. It is recommended to use
vacuum cleaner to clean it. Type number for this air purifying fi lter is <SPX-NTW2>. Please use this
number for ordering when you want to renew it.
Claws
(4 places)
EN3 RAS-RAC-S18CDT 17EN3 RAS-RAC-S18CDT 17 1/6/14 4:55 PM1/6/14 4:55 PM
To Next Page
Loading...
Need help?
General
