– 19 –
2. Washable Front Panel
● Remove the front panel and wash with clean water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with clean
water.
● When front panel is not removed, wipe it with a soft dry
cloth. Wipe the remote controller thoroughly with a soft
dry cloth.
● Wipe the water thoroughly.
If water remains at indicators or signal receiver of indoor
unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to detach
and attach it.
CAUTION
● Do not splash or direct water to the body of the unit when cleaning it
as this may cause short circuit.
● Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because they will damage the plastic surface and the coating.
Removing the Front Panel
● When the front panel is fully opened with both
hands, push the right arm to the inside to
release it, and while closing the front panel
slightly, put it out forward.
Attaching the Front Panel
● Move the projections of the left and right
arms into the Flanges in the unit and securely
insert them into the holes.
Flange
Hole
Projection
3. MAINTENANCE AT BEGINNING OF LONG OFF PERIOD
● Run the unit by setting the operation mode to
(CIRCULATION), the temperature to 16°C and the fan speed
to HI for about half a day on a fi ne day, and dry the whole
of the unit.
● Switch off the power plug.
EN3 RAS-RAC-S18CDT 19EN3 RAS-RAC-S18CDT 19 1/6/14 4:55 PM1/6/14 4:55 PM
To Next Page
Loading...
Need help?
General
