Hitachi RCI-5.0FSN3 - 4 Indoor Unit Installation; Factory-Supplied Accessories

2-38
TC-12001
4-WAY CASSETTE
8
P5414946-rev.1
4. Indoor Unit Installation
4.1 Factory-Supplied Accessories
Check to ensure that the following accessories are
packed with the indoor unit.
The hose band, screws, washers and plastic bands
are put in the pipe insulation.
Table 4.1 Factory-Supplied Accessories
NOTE
Applicable Air Panel (Option): P-AP160NA1 (without Motion Sensor)
P-AP160NAE (with Motion Sensor)
O
Do not put any foreign material into the
indoor unit and check to ensure that none
exists in the indoor unit before the installation
DQGWKHWHVWUXQ2WKHUZLVHD¿UHRUIDLOXUH
etc. may occur.
O
Check to ensure that the ceiling is strong
enough. If not strong enough, the indoor unit
may fall down on you.
O
Do not install the indoor unit to outdoors.
If installed, an electric hazard or electric
leakage will occur.
'RQRWLQVWDOOWKHLQGRRUXQLWLQDÀDPPDEOH
HQYLURQPHQWWRDYRLG¿UHRUDQH[SORVLRQ
x
If any of these accessories are not packed with
the unit, please contact your contractor.
x
The air panel, the remote control switch and the
branch pipes are optional accessories which are
not included with the indoor unit.
Accessory
Q'ty
Purpose
Pattern Board
(Carton Board)
Checking Scale
(Cut and Take Out it from the Carton Board)
Cross Recessed
Head Screws (M6)
Washer with Insulation
Material (M10)
Washer (M10)
Drain Hose
Hose Clamp
Pipe Insulation
Pipe Insulation
Cord Clamp
Cord Clamp
Insulation
(5Tx50x200)
Insulation
(5Tx100x200)
4
4
4
2
6
1
1
1
1
1
1
1
Insulation
(5Tx25x500)
1
1
For Adjusting Space of False
Ceiling Opening and
Position of the Unit
For Fitting Paper Pattern
For Unit Installation
For Refrigerant Piping
Connection
For Drain Hose Connection
For Fixing Remote Control
Switch Wiring, Louver Sensor
and Insulation of Piping
For Covering Drain
Connection
For Covering Wiring
Connection
For Covering Drain
Connection