Hitachi RPI-5.0FSNE - Transportation and Handling; Outdoor Unit Transportation; Hanging Method Safety Warning

TRANSPORTATION AND HANDLING
11
10. TRANSPORTATION AND HANDLING
10.1. TRANSPORTATION OF OUTDOOR UNIT
1. Hanging Method
When hanging the unit, ensure a balance of the unit, check
safety and lift up smoothly.
 For Transportation
- Do not remove any packing materials.
- Hang the unit under packing condition with ropes
through the each square hole an apply the splints or
corrugated paper for the unit protection.
Õ DANGER:
Do not hang ropes at the wooden base.
 For Installation RAS-5~16FSN ; RAS-8~10FXN(E)
- Remove the wooden base.
- Apply two (2) ropes on the splints or corrugated paper
to protect the unit, and hang the unit as shown below.
(Rope Position)
CORRECT INCORRECT
 For Installation RAS-20~30FSN ; RAS-16~30FXN
Hang the unit under packing condition with four (4)
ropes.
Push through the wire ropes into the hang hole and
clamp the wires by using shackle as shown below.
Wire Rope
Do not remove
wooden frame and
plastic band
Angle of Wire more
than 60°
Do not apply any
force to this plate
(Both Sides)
Push through wire
rope into the hang
clamp it by using
shackle
2. Before Installation
Before installation work, check the availability of the
following parts which are packed inside the outdoor unit
fixed to the base plate.
10.2. FACTORY-SUPPLIED ACCESSORIES:
Accessory Q'ty
5FSN 8FSN(E) 10FSN(E) 16FSN 20FSN 24FSN 30FSN 8FXN(E) 10FXN(E) 16FXN 20FXN 24FXN 30FXN
Compressed Sheet - - - 1 1 1111 12222
Pipe Flange of
Refrigerant Gas
Piping
--- 1 11111 12222
Pipe with Flare Nut
of Refrigerant Gas
Piping
-11 - ----11----
Pipe with Flare Nut
of Refrigerant
Liquid Piping
--- - - -11- - -- 11
4 For Connection Hole of Operation Wiring
Rubber Bush
1 For Connection Hole of Power Source Wiring
Screw 3 Spare
NOTE:
If any of these accessories are not packed with the unit, please contact your contractor.
Rope
Wooden Base
Rope
Square
Hole
Square
Hole
Rope
Rope
A
ngle of Wire
more than 60º
Do not apply any
force to this plate.
(Both Side)
A
pply rope on
the splints or
corrugated
paper more
than 15mm
thickness.
Do not remove
paper frame and
plastic band
A
pply rope through the square hole