When bending the pipes, firmly fix the pipe at
the heat exchanger side.
Insulation
For Left Side Piping
For Right Side Piping
Contour of the Unit
Fig. 5.1 Liquid pipe
Bend the gas pipe at the flexible pipe part.
Insulation
Fig. 5.2 Gas pipe
11
Contour of the Unit
For Right side Piping
For Left Side Piping
0.8/1.0/1.3/1.5
a
b
c
For Rear Side Piping
For Rear Side Piping
Model
Small Cover
Right Side Cover
Left Side Cover
108 410 302
(unit:mm)
(1) Position of piping connection is shown in
Figure 5.1 and 5.2.
(2) Piping Direction for the Indoor Unit Three
directions of piping connection to the indoor
unit can be performed; to the rear side, the right
side and the left side of the unit, respectively.
Therefore, most appropriate piping for a room can
be selected.
5.2 Piping Connection
Right Side Piping
Take off the small cover from right side.
Left Side Piping
Take off the small cover from left side.
Rear Side Piping
Bend pipe backwards directly.
1.8/2.0/2.3
121 415 294
0.8/1.0/1.3/1.5
a
b
c
Model
108 480 372
(unit:mm)
1.8/2.0/2.3
137 484 347
To Next Page
Loading...