English
16
(Fig.6) When releasing your finger from the
remaining battery indicator switch, the remaining
battery indicator lamp goes off. The table 5 shows
the state of remaining battery indicator lamp and
the battery remaining power.
As the remaining battery indicator shows
somewhat differently depending on ambient
temperature and battery characteristics, read it as
a reference.
Fig. 6
NOTE:
䡬
Do not give a strong shock to the switch panel or
break it.It may lead to a trouble.
䡬
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
GRINDER OPERATION
CAUTION:
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the causes
of overloading.
NOTE:
䡬
To prevent injuries, this product has a function that
prevents unexpected motor rotation when the
battery is inserted. The motor will not run if the
battery is inserter while the switch is still ON. After
installing the battery, turn the switch off and then
back on again.
䡬
The G14DSL and G18DSL models are equipped
with a protection function that will shut down the
tool in the event of an overload.
Should the tool shut down due to an overload, turn
the power off and then turn it back on again.
An overload that stops tool operation and lasts
more than 10 seconds may not be released by
turning the power off and on. Should this happen,
remove the battery from the tool and reinstall it
before turning on the power switch.
1. Hold the grinder firmly by its housing and side
handle (Fig. 1).
The grinder produces a counterforce which must
be controlled by firmly holding onto the grinder.
2. Turn the grinder “on”. (Fig. 7)
While holding the grinder firmly, use one finger to
slide the switch to the “on” position.
3. Use light grinding pressure.
There is no need to press hard when grinding.
Usually the grinder’s own weight is sufficient to
allow the required light contact with the surface to
be ground.
WARNING:
Do not press the grinder forcibly against the
surface to be ground. Heavy pressure can result
in wheel breakage and serious injury. It can also
damage the surface being ground or damage the
grinder’s motor.
State of lamp Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery soonest
possible.
Table 5
Remaining battery
indicator lamp
Remaining battery
indicator switch
Fig. 7
Switch
ON OFF
01Eng_G14DSL_US 8/28/13, 16:2716
To Next Page
Loading...
Need help?
General
