34
NOTE: If you have a cable box or satellite box connected to this VCR, please refer to
"ANTENNA/CABLE CONNECTIONS" on pages 11 and 12 before proceeding to the next step.
1 Select the channel to be recorded
Press the number buttons on the remote control or the CHANNEL(CH) or button.
2 Select the tape speed
Press the TAPE SPEED button on the remote control to select the desired tape speed (SP/SLP).
3 Begin IRT
Press the REC/IRT button on the VCR as many times as needed. The recording length will be determined
by the number of times you press the REC/IRT button.
Each additional push will increase the recording time by 30 minutes. It can be set for up to 8 hours.
IRT (1:30)
SP
• Recording starts immediately when the REC/IRT button is pressed, whether you are watching the same or
a different channel.
• When the REC/IRT button is pressed 18 times, the VCR returns to the normal recording mode.
• To stop the IRT operation, press the STOP button on the VCR or on the remote control.
• To show the remaining time, press the DISPLAY button on the remote control so that "IRT" appears on
the TV screen. (It will show up momentarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning,
is 8 hours using T-160 (or 6 hours using T-120).
• The TV that is connected to your VCR may be turned on or off during IRT.
• If the tape runs out before the end time, the VCR will switch to the Stop mode immediately, eject the tape
and turn power off.
To Next Page
Loading...
