REF Access Description
Default
Value
Range Steps Units Application
Notes
Room Thermostats S SC S80 M
RTType Thermostats Type None
None
Wired
Wireless
- - ○ ○ ○ ○ -
- Compensation factors - 1-12 - - ○ ○ ○ ○ -
- Room Temperature Demand OFF - - - - ○ ○ ○ ○ -
- Check RT Address - - - - ○ ○ ○ ○ -
detectedRTh Detected Circuits - - - - ○ ○ ○ ○ -
Thermostat 1
(otC1)
Thermostat 1 -
None
C1
C2
C1+C2
- - ○ ○ ○ ○ -
Thermostat 2
(otC2)
Thermostat 2 -
None
C1
C2
C1+C2
- - ○ ○ ○ ○ -
Compensation Factors
• Circuit 1 (*1)
• Circuit 2 (*2)
? NOTE
• (*1):If Water calculation mode for circuit 1 in Heating (Water calculation mode for circuit 1 heating (C1WC)) or in Cooling (Water calculation mode
for circuit 1 cooling (CC1WC)) is not “Disabled”.
• (*2): If Water calculation mode for circuit 2 in Heating (Water calculation mode for circuit 2 heating (C2WC)) or in Cooling (Water calculation mode
for circuit 2 cooling (CC2WC)) is not “Disabled”.
Circuit 1
REF Access Description
Default
Value
Range Steps Units Application
Notes
Circuit 1 S SC S80 M
Rfacth1 Compen.Factor Heat 2 OFF / 1~5 1 - ○ ○ ○ ○ (*1)
Maxfacthp1 Max Compen.Factor Heat + 10 0-10 1 ºC ○ ○ ○ ○ (*1)
Maxfacthn1 Max Compen.Factor Heat - -10 -10-0 1 ºC ○ ○ ○ ○ (*1)
Rfactc1 Compen.Factor Cool OFF OFF / 1~5 1 - ○ ○ ○ ○ (*2)
Maxfactcp1 Max Compen.Factor Cool + 5 0-10 1 ºC ○ ○ ○ ○ (*2)
Maxfactcn1 Max Compen.Factor Cool - -5 -10-0 1 ºC ○ ○ ○ ○ (*2)
? NOTE
• (*1): If Water calculation mode for circuit 1 heating (C1WC)=Not “Disabled”.
• (*2): If Water calculation mode for circuit 1 cooling (CC1WC)=Not “Disabled”.
UNIT CONTROLLER
PMML0335A rev.1 - 04/2016
138