Supplement G
PLC Workstation
Power Consumption 24VDC±10% ;12W 24VDC±10% ;12W
Fuse Rating 0.5A 0.5A
Be sure to use all three terminals when connecting power. To
make a connection, strip about 0.64 cm (1/4") of insulation,
turn the screw counter-clockwise until the gap is wide open,
insert the wire all the way in, and turn the screw clockwise
until it's tight.
You must use Slo-Blo (type T) fuse for the Workstation. The
rating of fuse used for each model is shown in the following
table. The fuse holder is accessible from the bottom of the
Workstation.
G.4.1 Electrical Grounding
You must make sure that your Workstation is properly
connected to earth ground, to prevent it from radiating
radio frequency noise. You should also ensure that the
Workstation is on the same ground as any other equipment
connected to its communications ports.
If you connect a communications cable to your unit after
static electricity has built up or when the Workstation and
the other device are on different grounds, the resulting
discharge could damage the electronics in either device.
G-8
To Next Page
Loading...