HLC-200A
HITROL CO., LTD. 7
Precautions
for
Installation
Precautions
for
Removal
Safety
and
Environment
■ When fastening with bolts, it is recommended to fasten the washer to prevent loosening.
■ Connect the cable after checking the wiring diagram in the manual or on the sticker.
■ Check if the power supply is for AC110V or AC220V.
■ It is recommended to use AWG 13 or 14 cable for connection between controller and
level sensor.
■ When the distance between the controller and the level sensor is far (within hundreds to
500m) and the conductivity is low
■ It is recommended to use shielded cables when using in media.
(Operation performance and level sensing distance are slightly different when using cable
except recommended.)
■ Check the LED lighting after power on. (High: Red / Low: Green)
■ The power should be applied after the installation is completed.
■ Dismantling operation will cut off the power.
■ Remove in reverse order of installation
(Power OFF Release Locker Body Disconnection Wiring Disconnection
Socket Disconnection)
■ Notes during use
-Do not disconnect the cable while in use.
-Do not disconnect the product from the socket during use.
-Do not give a big shock to the product.
■ Cautions when connecting the product
-You should connect the terminal to the proper position of the wiring. (See wiring method)
■ Disposal of the product
-PCB and body inside the product housing should be discarded when the product cannot
be used.
It is recommended to disassemble and discard the part.
There are no accessories that affect the environment, so no special care is required.
To Next Page
