1. Open the foldable riser telescopic adjustment buckle.
2. Insert the telescopic vertical pipe in the same direc-
tion, adjust the required suitable height, and tighten the
adjusting buckle.
Note: If the adjustment buckle is too tight or too loose,
please adjust the screw at "3" appropriately.
Stand up
and close
the folded
riser in the
direction of
the arrow in
the picture.
After confirming that
the quick release
slotting is inserted,
lift the lever and
wrench in the
direction of the
arrow in the picture.
Press down the
folding wrench in
the direction of
the arrow in the
figure,lock the
folding riser.
Note: If the folding
wrench is too tight
or too loose, please
adjust the screw at
"1" appropriately.
-4-
INSTALL HANDLEBARS
ADJUST THE FOLDING TUBE
To Next Page
Loading...
