HITWAY BK8 - Front Fender Support Attachment; Install the Front Wheel; Front Wheel Preparation and Disc Brake Mounting

-5-
3. Install the Front Wheel
5. Use the assembled tool
to tighten the nut.
6. Use the No. 4 Allen key in the
16-in-1 tool to remove the fixing
screws of the mud plate support
rods pre-installed on the left
and right sides of the front fork.
1. Loosen the nut shown in the
picture with the No. 15 open-end
wrench in the 16-in-1 tool and
remove the support shaft.
7. Fix the front fender support to
the corresponding screw holes
of the front fork and use the No.
4 Allen key in the 16-in-1 tool to
tighten the screws.
5 6 7
1