www.karles.se
15
20mm);
• if it is necessary to raise the stove above the adjustment of the feet, make a brick base and
place the device on it (do not remove the feet needed for leveling);
• lack of proper leveling prevents proper operation of the door (it will not close properly);
2.9. Connecting the hot air distribution.
The hot air distribution system allows the convective heat generated by the furnace to be
used to heat other rooms. Depending on the power of the device and building conditions, different
solutions are used. Choosing the right one should be entrusted to a person or company with
experience in this field. A simple gravity system is perfect for small single-story houses. On larger
surfaces, sometimes it is necessary to use blowers forcing air circulation.
Freestanding stoves allow you to connect the hot air distribution system to the stove in too
ways: from the top (LUPO, CANE, LYNX) or from the bottom (LUPO, CANE). When installing from the
top, it is necessary to cut out fragments of the rear cover in the places marked in the drawing. We
gain uninterrupted airflow. When installing the pipes from the bottom, a blower to extract the heated
air is required in the system. Montage of the tubes is takes place by to a special set of fittings with a
diameter of 100mm. Cutouts allow with assembly to thin or thick sheet metal.
Fig. 12. Mounting connector with a diameter of 100mm.
To Next Page
