07
How to turn o Tamper alarm
Go to Siren Settings >Tamper detection
alarm.
Then switch the toggle to o to disable the
tamper detection alarm for 30 minutes.
Tamper detect will be automatically be
switched back on after 30 minutes.
You may want to switch o the tamper detection alarm
in the event that you want to move the siren, or change
batteries – to do this youcandisable tamper detect for
30 minutes.
1
2
3
To reset your Siren, find the connector joining the
power cable to the power supply (as shown to the
right). Quickly disconnect and reconnect 5 times.
The Siren should long beep once, and will go back into
pairing mode. Use your Hive app to install your Siren
again.
Troubleshooting
To Next Page
Loading...
Need help?
General