Need help?Do you have a question about the Hive Siren and is the answer not in the manual?
General| Type | Siren |
|---|---|
| Connectivity | Wireless |
| Wireless Protocol | Zigbee |
| Compatibility | Hive Hub |
| Color | White |
| Power Source | Battery |
Assess where best to position the Siren. It should be at a height between 2.5m to 3.5m.
Drill a 6mm pilot hole from the outside to the inside, then use a 12mm drill bit.
Cover cable end, thread from inside to outside, connect to power supply, and switch on.
Mark holes, drill, insert plugs, screw in, thread cable, attach plate, and tighten screws.
Unscrew battery compartment, remove tab, replace compartment, and tighten screw.
Insert power cable, wrap around guide, push excess cable back, and slide Siren onto mounting plate.
Pull excess cable inside, ensure power is connected and switched on.
Ensure Siren sounds in alarm by adding it to a Mode. Default is output in Away mode.
Siren light flashes automatically when Siren sounds. Can be used as a Hive Light.
Siren chirps to remind you to deactivate HomeShield when returning home.
Disable tamper detect for 30 minutes via Settings to move siren or change batteries.
Disconnect and reconnect power cable 5 times to enter pairing mode.
To Next Page