Hiwin LA Series - LAN5 and LAK4 D Installation Step 1

A99UE13-1304
70
2.LAN5 and LAK4D Installation
Step 1：
Align a bolt on LAK4D controller with a notch on LAN5 to insert downward(Fig. 1).
There is a tube-bolt circled in the g.2 to x an actuator and controller.
Step 2：(Release of LAK4D Fixer)
a.Putting the plug of Handset in the socket of Controller（The housing is made
”KP”）and Putting the plug of Actuator in the socket of Controller（The socket is
made ”1~4”）。
b.After inserting connectors of an actuator and a key box，vertically insert back
the xer on LAK4D controller (A) , and then fasten the up xer and down xer on
LAK4D controller (Fig. 3). Before inserting the main power cord，rotate out the
locker (B) along the arrow direction to insert power cord (Fig. 3) and then pull it
back (Fig. 3) along the arrow direction.
Fig. 1
Fig. 2
Tube-Bolt