• The electrical outlet must be protected by a 16A safety cut-out switch, separate ly from other
electricity consumers.
• The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm2 . The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this .
• Make sure that the power cable is undamaged and has not been installed under the oven or
over hot or sharp surfaces .
• The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation checked over by a qualified
electr ician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.
Design and Function
This chapter provides you with important safety notices on the design and function of the
device.
Overview
1. baking surface
2. temperature levels
3. temperature control ler
4. control lamp
5. base
6. crepes dough spreader
7. flat turner
Rating plate
The rating plate with the connection and performance data can be found on the bottom side
of the device .
`
To Next Page
Loading...
