Hkoenig STM45 - Fault Recovery; Troubleshooting Common Faults

Fault Recovery
Fault Recovery
Fault
Cause
Solution
The machine does not
work or the indicator light
of switch is not lighted
Power-off or fusion of fuse
Check and confirm
The socket is not connected or
plugged in properly
Connect to the power supply and ensure the plug is
plugged in thoroughly
Unfavorable connection of socket
Check whether the power socket is normal or not
The power switch is not turned on
Turn on the power switch
The indicator light is on
but there is no steam
The water in water tank does not
reach the designed water level
Fill water promptly
The water tank is not installed in
position
Install the water tank in position
Severe inflection of steam conduit
Straighten the steam conduit
Water don’t flow into boiler
Shaking water tank or re-placed the water tank
The accessories of ironing
brush are not fastened
Unaligned grip
Realign and fasten the snap close
Less, discontinuous or no
steam
The water in water tank does not
reach the designed water level
Fill water promptly
The water tank is not installed in
position
Install the water tank in position
Severe inflection of steam conduit
Straighten the steam conduit
Less volume of steam
Blockage of filter sieve
Wash the clearing plug at bottom
Blockage of water tank
Wash the filter sieve of water tank
Water don’t flow into
boiler
Blockage of water intake
Wash the water intake
The water tank is not installed in
position
Install the water tank in position
Water tank deformation
Used hot water
Replace the water tank
Overflow of water tank
Cracking of water tank
Replace the water tank
Breakage of seal ring
Replace relevant fittings
If the problems above are still not solved, inform the professionals and do not dismantle the
machine without authorization.