HMD Fusion - Page 8

Step 10 — Disconnect the power button
Use a spudger to pry up and disconnect the power button press connector.
Remove the back cover.
Step 11 — Remove the loudspeaker screws
Be careful not to puncture or damage the battery with your tool during the rest of this
guide.
Use a T3 Torx screwdriver to remove the three 3.4 mm‑long screws securing the
loudspeaker.
One of the screws on the loudspeaker may be covered by a sticker. Pierce through it
with your screwdriver or use tweezers to remove it.