Use
your
fingers to
lift
the
loudspeaker
out of the frame
by
its
metal bracket.
Remove the loudspeaker.
Step 13 — Disconnect the charging board
Slide one arm of a pair of tweezers under the metal neck of the black antenna cable’s (
Refer Page -2 on next Page ) connector head, near the center of the board.
Lift
straight
up
to disconnect the
cable.
Repeat for the white antenna cable.
To
reconnect the
cable,
hold the metal
head over
its
socket
and press
down
with
the
flat
end of a spudger—it should snap into place. If it's not connecting, reposition the
head
and try again.
To Next Page
Loading...
