r
OM 2012
1.
Base
2.
Gasket
3.
Element
4.
Shell
.
5.
Center stud
6.
Drain plug
Oil Filter
Figwe 7
.
(f) Place a ne:~ gcsket in the filter Lax (1).
(9) Position the shell and element carefully. on the base.. Be sure the shell
fits perfectly on the gasket.
Start the stud threads into the base while
holding the shell in position.
Tighten stud carefully to prevent damage
to the gasket and/or stud threads. Torque stud to 50-60 foot-pods
(68 - 81 Nom).
(h) &an the drain plug (6) and install securely.
(i) When the engine is fint started after completing the oil change and filter
change operations,
check the shell-to-gasket joint for possible oil leak.
E. Engine Accessories
See Figure 3 for identification of engine and accessories lubrication points, lubricction
intervals, and lubricants.
.’ .
(1) Alternator
Apply 5 or.6 drops of engine oil in each hinged cap oiler every 200 hours.
2-l
Page 8
Aug 25’85
To Next Page
Loading...
Need help?
General
