12. Maintenance and Care 213
It is in your own interest to have the brakes checked
regularly by your Fiat or Citroën- workshop.
For further information, please refer to the Fiat Ducato or
Citroën Jumper operating instructions.
12.2 Brakes
The components in the brake system are part of the General
Type Approval (“Allgemeinen Betriebserlaubnis“, ABE).
If you change the components in the brake system, the type
approval expires. Any changes are only possible if they have
been released by the manufacturer.
The following applies when maintaining the brake system
• Check the level of brake uid regularly.
• Check the brake system and brake hoses regularly for lea-
kage. Rodents often gnaw at rubber hoses.
• Use only brake uids with the same qualities as those
uids already in the brake circuit.
12.3 Changing the rear lights
2
Siesta
Optima rear light
Removing the cable
• Remove the defect lamp from
the lighting support and pull
out the cable by pressing the
two clamps
k
together.
• Unscrew the two screws
j
in the defect lamp.
If several lamps have to be replaced, take care to ensure
that they are not accidentally switched and that everything
is put back in its original place.
Before changing lamps, disconnect the power supply in the
vehicle and switch the ignition o.
Lamps can be hot!
Ensure that no liquids (e.g. rain) ow into the covers.
1
To Next Page
Loading...
Need help?
General
