Electrical Installations
• To avoid damage to the module, ensure that the plugs are
plugged in rmly.
• To switch off the power supply for the entire system, set the
main switch 230 to "0" (OFF).
• Connect and disconnect the system to the 230V external
mains only when the main switch is off.
• Should the switch be automatically interrupted, check the
system for defects before switching the power supply back
on.
Fuses
• Only replace defect fuses after you have found the reason
for the defect and xed it.
• The new fuse must have the same amperage as the old
one.
Siesta control panel
Description
1) Button for monitoring fresh water tank.
2) Button for monitoring consumer battery (B2).
3) Button for monitoring vehicle battery (B1).
4) LED signals test in fresh water tank; blinking signals emp-
ty tank.
5) LEDs signal level of fresh water tank.
6) LED signals test in sewage tank; blinking signals full tank.
7) Blinking LED signals full sewage tank; LED 6 also signals
alarm.
06-3
1
2
3
4
5
6
7
8
9
10
11
12 13 14 15
To Next Page
Loading...
