Hobie H-Crate - User Manual

Hobie H-Crate Assembly and Installation Instructions
1 4 x Corner With the flat surfaces aligned, insert 2 long and 1
short H-Rail section into two upside down corner
pieces. Then connect the remaining corners using
the short H-Rail segment sliding both assemblies
together. Ensure the rails go all the way into the
corners. You may need to push them together using
a flat surface for leverage.
Parts List
2 x Short Wall
4 x Strap
2 x Long Wall
2 x Long H-Rail
2 x Short H-Rail
1 x Bottom
8 x Self Drilling
Screws
8 x Thread
Forming Screws
Tools needed:
Phillips Screwdriver
(optional) Drill and
Driver Bit
3
2
4
5
6
7
8
9
1
Slide the wall sections into the corners using the
tabs at the top and bottom to align.
2 Align the bottom of the crate. To secure it, first push
in the centers of the walls to clear the center snaps
and install the thread forming screws in the corners.
(optional) To add extra ridgitiy, you may install the self
tapping screws into the holes on top of the corners
using a drill.
thread
forming
self
tapping
3
REV 141203

Summary

Hobie H-Crate Assembly and Installation

Parts List and Identification

Lists all components required for Hobie H-Crate assembly, including walls, rails, bottom, and fasteners.

Core Crate Assembly Steps

Instructions for assembling the H-Crate walls, rails, and bottom using provided parts and fasteners.

Installation and Securing Procedures

Guides on interlocking crate tabs, attaching straps to the kayak, and securing rods with bungee.

Customization and Accessory Ideas

Suggestions for customizing the H-Crate with accessories like rod holders and mounting plates.

Hobie H-Crate Specifications

General

Brand	Hobie
Model	H-Crate
Category	Fishing Equipment
Language	English