EasyManua.ls Logo

Hobot 368 - Specifications

Hobot 368
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 11 -
8. HOBOT does not move smoothly, or it moves irregularly.
(1) Cleaning cloth is too dirty, please replace it.
(2) The friction factor difference due to glass stickers, window film, etc. Please
avoid using HOBOT on the surface with special finish.
(3) The screw of the cleaning wheel might have become loose. Just tighten it.
(4) The cleaning ring is broken, please replace it.
9. After cleaning, swirl marks are left on the glass.
Cleaning cloth is too dirty or too wet, please replace it.
10. How to avoid leaving swirl marks on the glass which is visible under
strong light?
Use a pair of clean and dry cleaning cloth to wipe dust and dirt off the glass,
then use another pair of clean and dry cleaning cloth, spray small amount of
detergent or water only on the lower cleaning cloth while keeping the upper
cleaning cloth dry and clean the glass again.
11. HOBOT does not stop cleaning after completing the task.
Please press button to stop HOBOT.
12. Unable to link to App/HOBOT
(1) Please restart HOBOT and App.
(2) Please turn on Bluetooth function on your smartphone and connect.
(3) Please check the Bluetooth device list on your smartphone and select
“HOBOT”.
If any problems occur and this manual cannot provide the solution you need,
please contact a local retailer or local authorized dealer.
◎Specifications
Model
HOBOT-368
Adhesive type and shape
Vacuum, Round
Weight
895 g
Device size (LWH)
295×148×95 mm
11.4×5.6×3.7 in
Software
AI Technology V3.0
Cleaning method
Rotating, Zigzag
Suitable glass thickness
All thickness
Input voltage
100-240V, 50/60Hz
Power consumption
90W
Un-interrupt Power System (UPS)
20mins
Certifications
CE, FCC, RoHS