- 7 -
4. Safety procedures
(1) For windows with no balcony, a warning area must be established on the
ground below to prevent people from coming near it.
(2) Please check if the safety rope is broken or the knot is loose
(3) Fasten the safety rope and tie to an indoor fixture before using HOBOT.
5. Put HOBOT onto the glass
(1) Turn power switch on. Make sure fan is running.
(2) Put HOBOT onto the glass and keep 10cm away from the edge.
(3) Check if HOBOT is sticking to the glass before releasing it.
6. Cleaning with Auto Mode and Manual Mode
(1) Press or or , HOBOT will automatically clean the entire window.
(2) Press or to stop HOBOT.
(3) Press to manually control the HOBOT’s moving direction.
7. Finish and Remove HOBOT from Glass
(1) Hold the safety rope with one hand and grasp HOBOT tightly with the other
hand to remove HOBOT off the glass.
(2) Switch off HOBOT in a safe area.
◎UPS (Uninterrupted Power System)
(1) The UPS supplys power during power outage.
The backup time of the UPS is 20 mins.
(2) HOBOT will stop automatically, play alert, and
flash red and blue light. Please take down
HOBOT from the glass as soon as possible.
(3) The safety rope can be used to pull HOBOT
back. Gently pull the safety rope at an angle
close to the glass to avoid it from falling.
To Next Page
Loading...
