What to do if my Hochiki Control Panel shows Common Trouble?
If your Hochiki Control Panel displays a Common Trouble, you should: * Check for any missing interconnection wiring. * Check for any missing modules that are part of the configuration. * Check jumper positions. * Check for improperly secured cabling.
Why is my Hochiki HCP-1008EDS Control Panel showing a Battery/Charger Trouble?
A Battery/Charger Trouble on your Hochiki Control Panel can occur if the voltage is low (below 20.4V). Replace the batteries as soon as possible. If the problem persists, the main board may need to be replaced.
What to do if my Hochiki Control Panel displays a Ground Fault?
If your Hochiki Control Panel is showing a Ground Fault, check for any external wiring touching the chassis or other earth ground connection.
What to do if my Hochiki Control Panel is in Configuration Mode?
If your Hochiki Control Panel is stuck in Configuration Mode, it is possible that the configuration has been corrupted. Review and re-enter your configuration.
What to do if my Hochiki Control Panel shows Circuit Trouble?
If your Hochiki Control Panel displays a Circuit Trouble, check for open wiring on that particular circuit loop or see if the circuit disconnect switch is in the ON or CLOSED position.
What to do if my Hochiki Control Panel shows CPU Fault?
If your Hochiki Control Panel displays a CPU Fault, the main board must be replaced.
Guides on how to install the main chassis into the backbox.
Instructions for installing main and expander chassis into the HBBX-1024XT.
Details the physical mounting and cabling of circuit adder modules.
Shows terminal connections for the main fire alarm module.
Details terminal connections for the HDM-1008 detection module.
Illustrates terminal connections for the HSGM-1004 signal module.
Shows terminal connections for the HRM-1008 relay module.
Step-by-step guide for powering up the system.
Provides common error messages and their solutions.
Overview of system configuration using DIP switches and buttons.
Detailed list of functions controlled by configuration DIP switches.
Step-by-step guide to access and operate in configuration mode.
Procedure to exit configuration mode and return to normal operation.
Instructions to restore factory defaults or resize the system.
Process for setting the number and type of circuit adder modules.
Explanation of various configurable system features.
Steps for setting the type of initiating and indicating circuits.
Details how to configure correlations between different circuits.
General| Brand | Hochiki |
|---|---|
| Model | HCP-1008EDS |
| Category | Control Panel |
| Language | English |
To Next Page
