33
CLEANING AND STORAGE
- Always disconnect the appliance from the wall socket before cleaning, assembling or
disassembling the accessories or the appliance itself.
- Do not use abrasive cleaning agents, scrub pads, alcohol, solvents or metallic utensils to
clean the appliance or its accessories.
- Never immerse or rinse the appliance in water or any other liquid.
The appliance’s exterior
- Clean the appliance’s exterior with a soft and damp cloth and dry it with a clean and dry
cloth.
- Make sure that no water enters inside the appliance, to avoid damaging it.
- Whenever you notice hair or dirt accumulation on the wheels (A), clean them.
HEPA filter, motor’s filter and exhaust filter
- The HEPA filter (U) is wrapped with a mesh filter. Remove the mesh fister that covers the
HEPA filter (U) and wash both filters with running water. Never use detergents or any other
kind of soap, because it can damage the filter (U).
-
The motor’s filter (T) and exhaust filter can also be washed in running water, without using
any detergent or soap.
- If you choose to wash the filters, they should only be placed on the appliance when
properly dried. Never use them wet or moist.
Storage
- Switch off the appliance on the on/off button (E) and remove the plug
from the wall socket.
- Press button (B) to automatically rewind the supply cord (S). During this
process, keep the plug in your hand to avoid the abrupt movement of the
supply cord (T).
- Retract the bristles of the multifunction brush (L) to avoid damaging
them and close the telescope tube (J).
- To store the appliance vertically, insert the parking connector (I) into the
parking slot on the main body’s lower part.
REPAIRS
- This product has no user-serviceable parts. Do not attempt to repair the appliance on your
own. Always have a professional repair the product for you.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
EC DECLARATION OF CONFORMITYCONFORMIDADE
This appliance complies with the requirements of the Electromagnetic
Compatibility Directive (EMC) and the Low Voltage Directive (LVD),
34
therefore it was marked with the CE label and provided with a declaration
of conformity with European standards.
DISPOSAL OF WASTE EQUIPMENT
Waste electrical devices are made of recyclable materials. Do not dispose
of them with household waste as they may contain substances harmful to
human health and the environment! Please actively support cost-effective
management of natural resources and protect the environment by taking
the waste appliance to a collection point for recyclable waste electrical and
electronic equipment.
SYMBOLS EXPLANATION
This symbol indicates that the user manual is included in the product
packaging and must be read before use.
The „Green Dot” trademark located on the packaging means that the
entity, for whom the product was manufactured, made financial
contributions in construction and operation of the national recovery and
recycling system for packaging waste in accordance with the principles
resulting from the laws of Portugal and the European Union concerning
packaging and packaging waste.
This product meets the requirements of Directive 2011/65/EU, referred to
as RoHS directive. The purpose of the Directive is the approximation of the
laws of the member states concerning the restriction of use of hazardous
substances in electrical and electronic equipment, and the contribution
towards the protection of human health and the environmentally sound
recovery and disposal of waste electrical and electronic equipment.
RoHS Directive applies from 3 January 2013. New electrical and electronic
equipment put on the market shall not contain lead, mercury, cadmium,
hexavalent chromium, polybrominated biphenyls or polybrominated
diphenyl ethers.
CLASS II indicates anti-shock protection of product not only depends on
basic insulation but also includes additional precaution. For example
To Next Page
Loading...
