EN
[38]
ELECTRIC BARBECUE 2 IN 1
The stand must be as shown in the gure on
the side.
Fit the lower grid (I) on the stand (J).
You can then place the completely assembled
barbecue on the stand.
Assembly - Barbecue Stand
Turn the upper tray (A) upside down and x
the 4 plastic feet (G) using the small screws
(L) provided with the appliance. See gure
opposite. Note that the feet should all face
the same side.
Place the tray (A) facing up and with the
control panel groove facing you, as shown
in the gure on the side.
Place the zinc plate (D) inside the upper tray
(A) with the control panel sockets also fac-
ing you, as shown in the gure on the side.
To Next Page
Loading...