www.hoffmann-group.com
DE
EN
1.4. Procedure
Unpack the upright cabinet.
Open the emergency release (section 2).
Pull the first drawer out completely.
WARNiNG:
The drawer initially runs until it reaches the bottom stop, but can be pul-
led over it if pulled with some force. Only then does the drawer come free.
Repeat disassembly with all drawers.
Then place the cabinet shell in the subsequent installation location.
Please now secure the cabinet housing against tipping (section 3).
Before the drawers are mounted again, it is recommended that the
cabinets are commissioned electrically and are integrated with the
software.
Its function can now be checked (it is not necessary to mount a drawer
in order to check the ejection is functioning).
In order for commissioning to be carried out, it is
necessary to remove the side covers.
Please follow the procedure described in section 6
of the main documentation for commissioning.
Please do not forget to fit the “bus end piece” on
the last com ponent (see section 6 of the main
documentation).
After mounting a drawer, it is necessary to mount the approach
plate (this prevents the drawer from being pulled out completely).
Climb onto the ladder and mount the approach plates on the top
axle guides using a socket and ratchet.
11
To Next Page
Loading...
