User Manual LoRaWAN mME DTZ541 Three-phase electricity meter
15 / 32
7 PIN
7.1 INFO PIN
An optical data interface on the front is available for the end user. Its constant data rate is 9600 baud and the character
encoding is 8-N-1. The transmission protocol is according to SML specification version 1.04. The interfaces work in
"PUSH" mode and send out one data record every second. The data has 3 variants. If you do not enter a PIN for the
"INFO OFF" setting, it is the "Reduced data record", otherwise it is the "Complete data record". The “manufacturer-
specific data record” can also be activated or deactivated via the rear interface.
Record to the INFO-PIN
Manufacturer-specific data
record
• Manufacturer ID
• Device identification
• Meter reading + A, tariff-
free (without decimal
places, only for single-
tariff meters)
• Meter reading + A, tariff 1
(without decimal places,
only for two-tariff meters)
• Meter reading + A, tariff 2
(without decimal places,
only for two-tariff meters)
• Meter reading -A, tariff-
free (without decimal
places, only for single-
tariff meters)
• Meter reading -A, tariff 1
(without decimal places,
only for two-tariff meters)
• Meter reading -A, tariff 2
(without decimal places,
only for two-tariff meters)
• Manufacturer ID
• DeviceIdentification
• Meter reading + A,
tariff-free (only with
one-tariff meter)
• Meter reading + A,
tariff 1 (only for two-
tariff meters)
• Meter reading + A,
tariff 2 (only for two-
tariff meters)
• Meter reading -A,
tariff-free (only with
single-tariff meters)
• Meter reading -A,
tariff 1 (only for two-
tariff meters)
• Meter reading -A,
tariff 2 (only for two-
tariff meters)
• Current total active
power with sign
• Manufacturer ID
• Device identification
• Meter reading + A, tariff-free
(only with one-tariff meter)
• Meter reading + A, tariff 1
(only for two-tariff meters)
• Meter reading + A, tariff 2
(only for two-tariff meters)
• Meter reading -A, tariff-free
(only for single-tariff meters)
• Meter reading -A, tariff 1 (only
for two-tariff meters)
• Meter reading -A, tariff 2 (only
for two-tariff meters)
• Current total active power with
sign
• Active power L1
• Active power L2
• Active power L3
• Voltage L1
• Voltage L2
To Next Page
Loading...