Need help?Do you have a question about the Hollyland Solidcom C1 Pro Hub and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Battery Life | 10 hours |
| Charging Method | USB-C |
| Frequency Range | 1.9GHz |
| Compatibility | Hollyland Solidcom C1 series |
| Audio Channels | Full duplex |
| Wireless Range | 1100ft (350m) LOS |
| Transmission Range | 1100ft (350m) LOS |
| Communication Range | 1100ft (350m) LOS |
Describes the physical controls like volume knob, display, and operational buttons.
Details the ports for power input and battery connection.
Lists audio input/output and data network connections.
Specifies the port for connecting wired headsets.
Explains the icons and indicators on the hub's display screen.
Setting up network parameters like Wi-Fi, IP address, SSID, and password.
Configuring IP addresses, subnet masks, and gateways for wired connections.
Setting the hub to operate as a master or slave device.
Scanning for master devices and selecting one for slave configuration.
Options for assigning devices to groups (A, A/B, Custom).
Viewing the current group assignments for all connected headsets.
Adjusting the input gain for the PGM audio signal.
Setting the input gain for the 4-wire audio interface.
Adjusting the output gain for the 4-wire audio interface.
Switching between Standard and Cross line sequence modes for 4-wire.
Selecting cable compensation based on cable length for 2-wire.
Configuring terminal resistance for connected 2-wire devices.
Setting the input gain for the 2-wire audio interface.
Setting the output gain for the 2-wire audio interface.
Changing the display language of the hub.
Viewing system info like version and hardware number, and performing a reset.
Network configuration steps for accessing the hub's web interface.
Understanding the function of A/B buttons on headsets for group membership.
Recommended cable types and maximum lengths for cascading hubs.
Connecting and configuring two hubs using 4-wire analog signals.
Connecting and configuring hubs via IP network using RJ45.
Detailed steps for setting up hubs in master/slave modes via network cable.
Connecting three hubs using IP network and master/slave setup.
Lists detailed technical specifications including power, dimensions, range, and frequency.
Important safety guidelines to prevent hazards and damage to the product.
How to get help, contact support, and legal statements.
Compliance information with FCC rules and radiation exposure statements.
To Next Page
