User Manual
Before Using Your WiTouch Pro Device
Sync the Remote Control and the
WiTouch Pro Device
1. Using the provided screwdriver, remove
the back cover from the WiTouch Pro
device.
2. Remove the clear plastic tab from the
remote control.
3. On the remote control, press and hold
the (+) and (-) buttons simultaneously
until the LED appears solid green
(~ 10 seconds).
4. Quickly insert the batteries into the
WiTouch Pro device.
Note: The LED on the remote control
will ash several times indicating
syncing is complete.
5. Replace the back cover on the device.
Note: You may need to re-sync your
remote control and WiTouch Pro device
when you replace the battery in the
remote control. This will ensure communi-
cation between your remote control and
WiTouch Pro device. If your remote control
and WiTouch Pro device ever lose
communication, please repeat these
syncing instructions.
Hollywog
2830 Amnicola Hwy
Chattanooga, TN 37406 USA
+1 423 305 7778
info@hollywog.com
www.hollywog.com/witouchpro
® and © 2015 Hollwog, LLC. All rights reserved.
U.S. Patents 8,972,016, D712,052, D701,610,
D716,958. Other U.S. & Foreign Patents Pending
11S.1004J 09/30/2015
2
3
4
5
1
To Next Page
Need help?
General
