Snooze function - To activate the snooze function, follow the steps below
• Press the key “SNOOZE/LIGHT“, while the alarm sounds, to activate the snooze function.
• If the snooze function is activated, snooze symbol is ashing.
• The alarm will repeat after 5 minutes.
• The snooze function can be stopped by pressing any key.
12/24 hours mode - The time display can be in 12 hour (AM/PM) or 24 hour mode.
°C/°F temperature display - The temperature display can be in °C or °F. Press the key “-“
to switch between the mode.
Max./Min. Indoor/Outdoor
Temperature & Humidity
- Press “+” to display Max./Min. Indoor/Outdoor Temperature & Humidity.
•
Press “CHANNEL” to select the channel (CH1, CH2, CH3) if more than one outdoor sensor are within reach.
• Press and hold the key “-”, in the area of outdoor, select ON/OFF when ashing.
•
Press “MODE”, the upper limit temperature is ashing, use “+”, “-“ to set the maximum alert temperature.
•
Press “MODE “, the lower limit temperature is ashing, use “+”, “-“ to set the minimum alert temperature.
• When the alert is activated, the alert symbol will be shown.
Temperature Alert ON / OFF - Press and hold the key “-“ to set the temperature alert on or off.
•
Alert on: Temperature alert symbol shown in display
•
Alert off: Temperature alert symbol goes out.
Information
•
A temperature alert can be set-up for each channel.
•
The set-up process cannot be completed if the maximum temperature selected is lower than
the minimum selected temperature.
•
The minimum temperature selected must at least be 1°C below the maximum selected temperature.
WS5052B Weather Alarm Clock.indd 13 24/07/13 8:22 PM
To Next Page
Loading...