Outdoor Sensor
• Please install batteries in the Outdoor Sensor rst.
• Open the battery compartment located on the rear side of the device.
Place the batteries in the battery compartment. Observe the shown polarity.
• Please place in a sheltered position outside where it will not get wet or weathered.
Indoor Unit
• Open the battery compartment located on the rear side of the device.
Place the batteries in the battery compartment. Observe the shown polarity.
• The altitude will be ashing, use “+“ or “-“ to set the altitude of your position, then press
“HISTORY”, Weather symbol ashing, use “+“ or “-“ to choose the weather.
• The station is now connecting to the outdoor sensor. This process takes about 3 minutes.
Then the display shows the outdoor temperature and humidity, in case of failure of reception,
press “CHANNEL“ for more than 3 seconds to receive again.
• The ashing Radio controlled symbol will disappear when connected.
Manual Time Set-up
• Press and hold “MODE“ for 3 seconds.
• The display for the 12/24 is ashing. Use “+ “ and “-“ to select.
Press “MODE “ to conrm.
• The display for the hour is ashing. Use “+ “ and “-“ select the hour.
Press “MODE “ to conrm.
•
The display for the minutes is ashing. Use “+ “ and “-“ to select the minutes.
Press “MODE “ to conrm.
• The display for the year is ashing. Use “+“ and “-“ to select the year.
Press “MODE “ to conrm.
To Next Page
Loading...