What to do if my HOLZMANN MASCHINEN BT 46 Sander stops or will not start?
If your HOLZMANN MASCHINEN Sander stops or won't start, begin by checking the switch and all power connections. If that doesn't resolve the issue, allow the motor to cool down and reset it by pushing the off switch. You may also need to change the fuse, reset the circuit breaker, or replace the cable.
Why does the work piece burn during sanding with my HOLZMANN MASCHINEN BT 46 Sander?
If your HOLZMANN MASCHINEN Sander is causing the work piece to burn, the abrasive may be dirty from oil, so try changing it. Also, you might be applying too much pressure; reduce the pressure you are exerting on the material.
Why does my HOLZMANN MASCHINEN BT 46 Sander slow down when working?
If your HOLZMANN MASCHINEN Sander slows down during operation, you are likely exerting too much pressure on the sanding abrasive. Reduce the pressure you apply to the workpiece.
How to improve bad grinding results with my HOLZMANN MASCHINEN BT 46?
If you're getting bad grinding results with your HOLZMANN MASCHINEN Sander, the abrasive might be too coarse-grained. Try using a less coarse abrasive.
Why is there too rapid wear of abrasive on my HOLZMANN MASCHINEN Sander?
If the abrasive wears out too rapidly on your HOLZMANN MASCHINEN Sander, it may be too fine-grained. Try using a more coarse abrasive.
What to do if grinding angle is wrong on my HOLZMANN MASCHINEN Sander?
If the grinding angle is wrong on your HOLZMANN MASCHINEN Sander, the adjusted angle is likely incorrect. Readjust the angle to the correct setting.
What to do if sanding disc runs out of round on my HOLZMANN MASCHINEN BT 46?
If the sanding disc on your HOLZMANN MASCHINEN Sander runs out of round, it's likely mounted eccentrically. Remount the sanding disc centrally.
What to do if sanding belt runs out of sanding belt bed on my HOLZMANN MASCHINEN BT 46 Sander?
If the sanding belt on your HOLZMANN MASCHINEN Sander runs off the sanding belt bed, the sanding belt is probably mounted incorrectly. Remount the sanding belt centrally.
General| Belt Size | 915 x 100 mm |
|---|---|
| Disc Diameter | 150 mm |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Table Tilting | 0° - 45° |
To Next Page
