12
Troubleshooting
Review the following pages before calling for service.
Problem
Possible cause
Solution
The timer knob
does not turn.
The drum does not
turn.
Hot air is not
blowing out.
The laundry is not
thoroughly dried.
The dryer does not
start
• The power cord is not properly
inserted.
• The door is not closed.
• The power cord is not properly
inserted.
• Receptacle does not have power.
• The timer is incorrectly set on cold
air.
• The front and back filters are
clogged.
• Too much laundry in the dryer.
• Items have been added whilst the
dryer is in operation.
• Laundry has become twisted whilst
drying.
• The dryer is in a small location with
poor ventilation.
• The dryer is set on ‘Anti-wrinkle’.
• There is a power failure.
• The power cord is not inserted firmly.
• The door is not closed.
• The timer is in the ‘OFF’ position.
• Ensure the power cord is
firmly inserted.
• Close the door.
• Insert the power cord firmly.
• Check the power cord
receptacle.
• Set the timer to hot air.
• Clean the filter.
• Reduce the amount in the
dryer.
• Dry the items again.
• Untwist items and dry them
again.
• Place the dryer in a well-
ventilated area.
• Use the ‘Warm or ‘Hot’
setting.
• Ensure there is power, then
try again.
• Insert the power cord firmly.
• Close the door.
• Set the dry time.
Dryer Technical Specifications
NOTE: Consistent with our continuing product development policy,
improvements may have been made to the product. Contents in this manual may
slightly differ from the actual product.
To Next Page
Loading...
General