Home HME020020N - Cleaning and Maintaining Your Air Purifier; How to Replace the Filter; Cleaning the Unit Housing

8
CLEANING AND MAINTAINING YOUR COMPACT AIR PURIFIER
WARNING: Always make sure the appliance is turned off and unplugged before cleaning.
Follow the steps below to change the lter in your appliance:
1. Rotate the bottom cap counterclockwise to open and detach the bottom cap as shown
in gure 1 below.
2. To change the lter, please remove the old HEPA lter from the appliance and insert the
new lter as shown in gure 2 below.
3. Place the bottom cap back onto the appliance and twist clockwise till you hear it click in
place. This indicates that the bottom cap is fastened to the appliance appropriately.
4. Use a thin object like a toothpick to press the “change lter indicator” for 3 seconds. The
indicator will ash and the buzzer will sound 3 times indicating the lter has been reset
successfully.
5. The appliance can now be operated normally after being plugged in.
Cleaning the surface of the housing
1. Turn off the appliance and unplug the adapter.
2. Use a soft cloth to clean the surface of the housing.
3. Place the air purier in a well ventilated environment, do not expose to the sun directly
and only turn it on when it is thoroughly dry.
WARNING: Do not clean the appliance with water or any other detergent. If water or cleaning
detergent gets into the appliance, damage may occur.
Fig. 1
Fig. 2 Fig. 3
HEPA Filter w/
Active Carbon
Press for 3 seconds to reset the
“Change Filter” indicator.
Boom Cap
Adapter
Connector